Hmmmm... :impatient:
Not too impressed at the moment. I might as well give you a 'warts and all' commentry, otherwise it would be a pointless excersise if I just said everything was fine - even though I know that IP will sort my problems out without any fuss.
Start at the beginning:
After taking the above photo I leafed thru the instructions and found a page missing. Phoned IP and asked them if they had it in PDF format that they could e-mail me, rather than send me a bit of paper. No problem, it arrived 2 minutes later.
This evening I read thru said instructions... 'Fit dah-da-da to dah-di-dah' etc. until I reach 'Fit the buffers'. No buffers. That's fine, I'll call them tomorrow and they'll be here next day.
Decided to pop out the side and base panels to get a feel of the thing and found that one end of the base has only been cut half way thru. I needed my band saw to do a neat job to cut it out - this is tough plywood and a standard craft knife wasn't up to it. I'll mention this tommorw when I call them and see what they say.
Anyway, the upside is that it looks like it's going to make up to a substantial model (and I always enjoy a challenge!)