After some research and comperisment of a lot of 3d printers the Creality Ender 5plus was suited the best for me.
Incl safety and the bed levelling device.
The bonus point for me was the surface area.
To make this one 2x as big is also a no brainier.(50cmx100cm)
The temperature range is a bit more extended than most.
Basically this is a fool proof, nice and easy ready to go printer.
Di spite the large building area, question yourself first if you need it this big, if the answer is yes, go for it and leave the 10 series alone.
If no, go for a smaller Ender.
I had prints running for 6 days
If you go for a big one, in time you want to have a smaller one extra.
If you want to print a thingy of 5x5 cm it is a waste of time to start up "the beast".
Pla is nice to get started, but abs is better for outside and hot attics.
Next level is resin printers, they are almost heaven, but will put you thru hell first
Hope this was helpful, my two cents,
With best regards Igor.