Massoth Di Max Navigator Reset :-(

[Steve]

Good afternoon all been a while since my last post , i have a Dimax navigator ( Upgraded to wireless )that i run through a MTS3 system just purchased a new Rugen for my soon to arrive grandaughter Paul at SP models did all the hard work setting it up for me on number 14 .

Long time since i have added a loco instead of reading any instructions ( bloke mode on ) i went in all guns blazing and have reset it so now my loco is a shelf queen

When i power it on it just comes up with the blow and goes blank

Any help would be really appreciated

 

[Gizzy]

Not clear in your post Steve, but have you deleted all loco addresses on your Navigator?

Can you still control a loco if you put the address in manually?

Display going blank might be due to batteries....

 

[Steve]

Hi Gizzy ,

No i have done a full factory reset so it just flashes up with the screen i posted . Also tried new batteries .

 

[Gizzy]

Oo-er, unless you have a back-up of your data Steve, I guess that you'll have to start over....

 

[Steve]

Controller sent to P&S models to have life breathed back into it