(LGB point motors and switches) Didnt know where to post this...so....

Sorry for bringing back an old thread, but could LGB Points or Signals be powered from a 12 volt AC output power supply and an LGB switch box?
 
Sammler said:
Sorry for bringing back an old thread, but could LGB Points or Signals be powered from a 12 volt AC output power supply and an LGB switch box?
Click to expand...


I don't believe that 12 volts is enough power to operate the switch drives. Normally, the LGB AC output, on their transformers is about 19 volts. And even then a power boost is required to operate the switch drive. It is possible to operate LGB switch drives using DC and a monetary DPDT toggle switch. Similarly, Piko switch drives actually require DC to operate. Their system is set up for DC operation. The only disappointing aspect of Piko switch drives is they weak connection of their supplementary switch to the drive. I tried a few. While the switch drives worked very well, better than LGB I think, I had to secure the supplementary switch to the switch drive with zip ties.
 
They will work off of a 12v battery.
 
I find mine are a bit sluggish and a touch unreliable on 12v so I use 15v+. It may be volt drop on the cable, but I don't think they are that long (max 20ft ish) though they are light section.
 
You must log in or register to reply here.
Back
Top Bottom