Simon Potter
Srpott40
hi
I run a massoth the system and have a range of different locos which have a variety of chips installed. My railway does not have any of these fancy train detection systems or automatic points etc. As my railway is quite large I often enjoy setting two trains running then enjoy watch them run! However one always seems to catch the other up. (Even if set to same level on controller)
Do anyone have a way of changing the loco cv so that they run the same speed? I have a large range of locos so trail and error on the speed steps is not my preferred option!!
I run a massoth the system and have a range of different locos which have a variety of chips installed. My railway does not have any of these fancy train detection systems or automatic points etc. As my railway is quite large I often enjoy setting two trains running then enjoy watch them run! However one always seems to catch the other up. (Even if set to same level on controller)
Do anyone have a way of changing the loco cv so that they run the same speed? I have a large range of locos so trail and error on the speed steps is not my preferred option!!