Too much smoke?

H

Huh? What?

Registered
Country flag
Got the Harbor Models smoke unit installed and wired into the G8 decoder. It may be producing more smoke than I want. However, I currently have it wired into straight 12vdc. Harbor Models suggests wiring in with the motor, which will vary the smoke for the speed of the engine. That's my next step. Everything is working, though.


 
Try a lower voltage and duct the smoke to your exhaust pipe harbor models tell you
in there web site.
Ron
 
The only way to get a lower voltage is to add a resistor, which I may try. It's currently hooked to the motor, which varies the smoke by the engine speed. As far as the exhaust pipe, the dragon skull is the exhaust pipe, so it's ducted to the exhaust pipe already. The problem is that at full voltage, the smoke blows back through the unit and fills the inside of the car.
 
I thought perhaps the suggestion was to the smoke stack from the back of the car, a little Y fitting and bit of hose to the back?

Have you calculated your resistor yet? If you are running 12 volts and an amp, and you want to drop say 2 volts, then you would need a 2 ohm resistor, but also a 4 watt one (rule of thumb is to double the calculated wattage)... dropping 2 volts in the resistor should give you 10 volts to the smoker.

(sorry if you already calculated this yourself, no insult intended)

Greg
 
Greg Elmassian said:
I thought perhaps the suggestion was to the smoke stack from the back of the car, a little Y fitting and bit of hose to the back?

Have you calculated your resistor yet? If you are running 12 volts and an amp, and you want to drop say 2 volts, then you would need a 2 ohm resistor, but also a 4 watt one (rule of thumb is to double the calculated wattage)... dropping 2 volts in the resistor should give you 10 volts to the smoker.

(sorry if you already calculated this yourself, no insult intended)

Greg
Click to expand...

A 'buck' convertor would be more efficient, but you would loose any variable smoke effect..
 
Huh? What? said:
Got the Harbor Models smoke unit installed and wired into the G8 decoder. It may be producing more smoke than I want. However, I currently have it wired into straight 12vdc. Harbor Models suggests wiring in with the motor, which will vary the smoke for the speed of the engine. That's my next step. Everything is working, though.


Click to expand...
I think the beast looks better with more smoke, all you now need to do is fit a flame gun inside and you have it cracked!
 
Use diode's ie. 1N5401 each diode will drop .7 of a volt so using 4 diode's you will drop approx 2.8 volts
 
OK, less elegant then?

To keep it simple, 0.7V across each diode (I believe four were mentioned?) and if you are pulling 1 Amp, then 700mW per diode of heat to get rid of..
Though I suppose there is plenty of space in the baggage section??
 
You must log in or register to reply here.
Back
Top Bottom