Setting up automation

[gscalerookie]

This was the original reverse loop with an oval. Ran great! Then I wanted more as usual so I said let’s do detection. No matter how I hook this up I keep getting a short. I’m using bd2o, ait and nce 10amp system. Could someone be kind enough to show me where to place the the insulation, where the wire for the reverse goes and regular track power.

 

[gscalerookie]

This was the original reverse loop with an oval. Ran great! Then I wanted more as usual so I said let’s do detection. No matter how I hook this up I keep getting a short. I’m using bd2o, ait and nce 10amp system. Could someone be kind enough to show me where to place the the insulation, where the wire for the reverse goes and regular track power.

Using nce ar10 for rev loop

 

[korm kormsen]

insulate all four connections to block 7!
(both rails)

 

[dunnyrail]

This was the original reverse loop with an oval. Ran great! Then I wanted more as usual so I said let’s do detection. No matter how I hook this up I keep getting a short. I’m using bd2o, ait and nce 10amp system. Could someone be kind enough to show me where to place the the insulation, where the wire for the reverse goes and regular track power.

Have a watch of this vid which shows quite clearly how I wired up and isolated a reverce loop using an LGB module, isolations will be the same to prevent your short circuits.