Programming MTS Locos

D

Dinas Bryn

Registered
Evening all having another go at using LGB MTS 55015s page 60 and diagram on 61 using a track, with the set-up instead of showing C-- it showed P. How do I change this to C--? Les
 
Dinas Bryn said:
Evening all having another go at using LGB MTS 55015s page 60 and diagram on 61 using a track, with the set-up instead of showing C-- it showed P. How do I change this to C--? Les
Click to expand...

Don't think you can mate! The software in your 55015 is an older version which shows P, not C. CVs 1 to 4 can be programmed directly: just enter the CV number when your 55015 shows P, instead of C.

Programming CVs 5 and above is a bit of a palaver: to program them needs an indirect system, which is described on 30 of the 55021 manual. You can access that from here:
http://www.champex-linden.de/lgb_pr...BBF200AAA0FEE85256BDB0057F3E1/$FILE/55021.pdf

If you can live without your 55015 for a while (typically 4-6 weeks), it's worth getting Massoth to upgrade your 55015 to parallel mode. Not particularly because of it being parallel, but programming can then be done directly to any CV and the visual indications for points and loco directions are enhanced. Cost will be around 50 Euros including return postage. If you decide to upgrade, just send direct to Massoth with a covering note. They will invoice you by e-mail and you can pay by Paypal. http://www.massoth.de/ < Link To www.massoth.de
 
You must log in or register to reply here.
Back
Top Bottom