I operate the Massoth DCC system. I have four mts switch contols working successfully 1-16 which were programmed when I used MTS. I now have a secondhand Dimax 8156001 which I am unable to program even though I have the instruction booklet. Yes I am reading the English section but it might as well be in Chinese. Can anyone provide a basic step by step way to program for points 17 +. I do have a separate test track wired to control centre. Thanks Roger
Massoth Dimax 8156001
- Thread starter rogeley
- Start date
Connect it to your programming track.
Connect a point motor to the first outputs (SW1).
Reset it to factory defaults.
Set CV2 to 77
Set CV7 to 55
Programme the addresses...
Set CV32 to 17 (Address of SW1)
Set CV34 to 18 (Address of SW2)
Set CV36 to 19 (Address of SW3)
Set CV38 to 20 (Address of SW4)
Set CV2 to 0
Connect a point motor to the first outputs (SW1).
Reset it to factory defaults.
Set CV2 to 77
Set CV7 to 55
Programme the addresses...
Set CV32 to 17 (Address of SW1)
Set CV34 to 18 (Address of SW2)
Set CV36 to 19 (Address of SW3)
Set CV38 to 20 (Address of SW4)
Set CV2 to 0
Thanks for info. in plain English! Hope to complete set up over weekend and have trains fully running weather permitting. Rogermuns said: