I have recently re-programmed all my locos using my Massoth handcontroller 8134501. To do this I could only have 1 loco on the track at once. Re- programming was successful. However there is now no response from my points attached to a Massoth switch decoder 8156101. I suspect that I have inadvertently deactivated the decoder. Could anyone please tell me how to reactivate. The Massoth instructions might as well remain in German ! I’m afraid explanations will have to be very simple. My mind cannot compute things like CV addresses and the like. Many thanks in anticipation of your expertise.
Clive
Clive
Last edited: