Control/mimic panel

[gscalerookie]

I want to build one of those control panels for a reverse loop
Nce 10a system
Points are controlled by 2-Nce switchkat and 1- psxx-arsc
I did some research and came across the Nce mini panel but what I don’t know is how to wire the point indicator led?
So my question is how to wire in leds to indicate point direction

 

[gscalerookie]

I found some info but it seems to contradict each other

 

[gscalerookie]

Here’s the other piece i found. So I’m leaning towards a light it to accomplish the control panel?

 

[JimmyB]

You must remember that G Scale points are NOT self isolating like other scales!

 

[dunnyrail]

If you are using LGB EPL point motors (not sure I understand or know the tech you are using) you can add a switch ref 12070 to the motor that is effectively a DPDT (double throw double pole) switch which would give you more than enough contacts to wire in the LEDs.

 

[gscalerookie]

You must remember that G Scale points are NOT self isolating like other scales!

I thought that was for adding insulated rail joiners?

 

[gscalerookie]

If you are using LGB EPL point motors (not sure I understand or know the tech you are using) you can add a switch ref 12070 to the motor that is effectively a DPDT (double throw double pole) switch which would give you more than enough contacts to wire in the LEDs.

I am using lgb point motors controlled by nce switch kat which allows me to control the points through dcc commands. I want to build a mimic/control panel of the reverse loop/oval. I picked up a nce mini panel that says it makes it easier to build a panel without all the wiring