Aristo fishplate tap.

[Nodrog1826]

Looking for one of the above, cause guess who has just gone and snapped the last one he has.

Its a 2m X 0.4 pitch R/hander I believe, unless someone wants to correct me.

I know they were sold as a set with the matching drill, but the word there is were..

So if anyone can at least point me in the direction of where to get one from.

 

[bobg]

Gord, ring Tracy Tools in the morning and you will have one on Monday. If you'd rung before 15.00 today, you'd have it tomorrow. They will sell you a set, or a single, with or without drill.


01803 328 603‎

 

[JRinTawa]

Gordon, a standard 1.5mm or 1/16th (1.6mm) drill bit will do. I use a 1.5mm which gives a 75% root diameter, the 1/16th will give near enough to an 80% root diameter which is I guess is probably more than ample. I replace these drill bits quite often, blunt ones are easier to break, and yes I break a few

 

[Nodrog1826]

Thanks for the info.[e]339[/e]

Three sets ordered from Tracy Tools, taps and drills, so should be sorted next week.