Prints turned out fantastic using the AMOLEN 30% walnut PLA.
Zero complaints and pleasantly surprised how easy it was with almost no modifications of settings.
I had one failure on my first print as I forgot to lower the stock print speed of 80mm/s which my ender 5plus usually runs at. Recommended is 40-60mm/s.
It's also important to note this is with a brand new 0.4mm nozzle. Meaning the nozzle wasn't worn which bores out the hole increasing the diameter. I've seen other wood filaments which recommended a minimum 0.5mm nozzle which is a hassle. No need for that here!
Successful settings were:
210C
120% flow (but I use this for all my filaments as my ender 5 plus has a tendancy to under extrude - you may not need this.)
50mm/s print speed
60C heated bed
This filament even did a better job on the internal supports than I usually get. Regardless of filament my supports are often under extruded even if the outer walls are great.
Not this time though!
I bought this one after seeing Amazon reviews that said it printed just like regular PLA. Can happily confirm and highly recommend.
Now that it's loaded and is even printing better than my usual polyterra filaments I'm looking for the next project. I think maybe an agricultural style multi track crossing so the boys can get their tractor to the farm in the middle of my layout
