Question: Piko volume Pot to XLS...?

[Zerogee]

I've been discussing this with a few others on the BR24 installation thread, but in case some folks haven't been reading that I thought I'd pose this particular question to a wider audience....

The Piko BR24 comes with a pre-installed volume control pot, which is not connected up; it has three vacant screw terminals labelled (from left to right) "G", "I" (or "1"?) and "O" (or "0"?).

Would anyone here have any idea how those three connectors correspond to the the external pot connections on a Massoth XLS, which are marked "GND", "POTI" and "+5V"?

Thanks in advance to anyone who knows.... I don't want to risk letting any magic smoke out with a wrong connection....

Jon.

 

[PhilP]

Put an Ohm meter across the pins..
From memory, the Massoth volume control is 5K. Two pins should give the full value of the potentiometer, and between either of these and the third connection should vary as the pot is turned.
Either end of the track goes to ground and +5V, the third connection is the wiper.

 

[Zerogee]

Thanks Phil - Mark (Muns) has just posted a diagram to the original BR24 thread which should do the trick!, so ta to both of you!

Jon.