Pilo 25015 booster connection to Lenz LZV100

S

Stan Ames

Registered
23 Mar 2020
1
0
70
Chelmsford, Massachusetts
The Piko 35015 booster uses a 6 conductor RJ12 connector. Does anyone know the pin layout of the connector and have a method for using this booster with other DCC systems such as a Lenz LZV100 or 200.

Thanks

Stan
 
PhilP

PhilP

G Scale, 7/8th's, Electronics
5 Jun 2013
24,915
1,060
Tamworth, Staffs.
I would be VERY careful about this!

I doubt the two will be compatible..

I had to send items back to both manufacturers, when a 'helpful person' plugged a Digitrax throttle into a Massoth piece of equipment. :( £££ :banghead:
 
dunnyrail

dunnyrail

DOGS, Garden Railways, Steam Trains, Jive Dancing,
25 Oct 2009
16,306
1,048
71
St.Neots Cambridgeshire UK
I would be VERY careful about this!

I doubt the two will be compatible..

I had to send items back to both manufacturers, when a 'helpful person' plugged a Digitrax throttle into a Massoth piece of equipment. :( £££ :banghead:
I would imagine that Phil is giving top advise here, ignore at your peril I imagine.
 
Greg Elmassian

Greg Elmassian

Registered
8 Mar 2014
3,452
352
San Diego
www.elmassian.com
I'd contact Shourt Line in the US... I see the stock unit comes with cables, and a "bus splitter" so the interface is probably a unique data stream.

$270 is a lot of money for a 5 amp booster, I use Tam Valley, about $60 as a remember plus a $50 power power supply.