Nicki &Frank S Sound Axle

shropshire lad

shropshire lad

Registered
Country flag
Can you fit a Massoth sound axle to a Nicki & Frank S?
I can't see if the quadrant plates on the motion are screwed into the axle centre or not and don't want to strip it down til I'm ready to do the job
Cheers Colin
 
yes, but ill ave a chat at phils!,or here, or there..i chat for cake
 
I've fitted one in a tender on a N & F. No problems.
 
I hate to say what he may do for JD:rolf:
 
Cheers for that Mike (Dutchelm)
I'm looking to do some slow running videos so I need good synchronisation of the sound and motion. An engine axle is probably going to be better if possible
 
shropshire lad said:
Cheers for that Mike (Dutchelm)
I'm looking to do some slow running videos so I need good synchronisation of the sound and motion. An engine axle is probably going to be better if possible
Click to expand...
The standard axle supplied is only a replacement for short (inside bearings) axles. It is not long enough to connect fly cranks on the outside. You would need to make a special axle to take the magnet.
The synch on my tender drive is fine.
 
You will need the soundaxle from a croc or OBB diesel (spare part) AND the Massoth kit for the sensor and magnet. The old LGB sensor cannot be used with Massoth units.
 
You must log in or register to reply here.
Back
Top Bottom