Nicki &Frank S Sound Axle

[shropshire lad]

Can you fit a Massoth sound axle to a Nicki & Frank S?
I can't see if the quadrant plates on the motion are screwed into the axle centre or not and don't want to strip it down til I'm ready to do the job
Cheers Colin

 

[mike]

yes, but ill ave a chat at phils!,or here, or there..i chat for cake

 

[dutchelm]

I've fitted one in a tender on a N & F. No problems.

 

[shropshire lad]

yes, but ill ave a chat at phils!,or here, or there..i chat for cake

I better bring some cake then

 

[Steve]

I hate to say what he may do for JD

 

[shropshire lad]

Cheers for that Mike (Dutchelm)
I'm looking to do some slow running videos so I need good synchronisation of the sound and motion. An engine axle is probably going to be better if possible

 

[dutchelm]

Cheers for that Mike (Dutchelm)
I'm looking to do some slow running videos so I need good synchronisation of the sound and motion. An engine axle is probably going to be better if possible

The standard axle supplied is only a replacement for short (inside bearings) axles. It is not long enough to connect fly cranks on the outside. You would need to make a special axle to take the magnet.
The synch on my tender drive is fine.

 

[palmerston]

You will need the soundaxle from a croc or OBB diesel (spare part) AND the Massoth kit for the sensor and magnet. The old LGB sensor cannot be used with Massoth units.