need a advice ABOUT 2 SAME rite hand points....will work?...

[steven large]

I NEED a help....i know it sound silly but just want to make sure if work for normal tracks...or ? any advices?...post me a comments within yr great help....
if i use the same rite hand points for my loco to pass the 1st point and then go around to the second same rite hand point but it will ok or ?......

 

[ntpntpntp]

Hi Steven,

you're creating a reverse loop with that track configuration as you can see from where you'ved traced + and - on your drawing, so you'll need the usual method of isolating fishplates on both rails at both ends of the loop and a method to reverse polarity somewhere in the loop.

 

[Gizzy]

I concur with Nick above.

I've edited your diagram to show you how to wire in the switch (red/blue), and where to put the isolators (in yellow).

The other way is to use LGB 1015T revering loop set, but this is about £35 new and will only allow trains to run in one direction in the loop, but you will not need to do any wiring for this case....

(If I remember correctly Steven, you are an analogue operator.)