Massoth 8132701 Feedback Transmitter. Power Source.

F

frankando12

Registered
Country flag
I was wondering how the Massoth 8132701 wireless Feedback Module is powered would it be powered by a Battery pack as it only requires 3v or is there any track power system that is used. Massoth doesn't seem to say in the Manual.
 
Track power i would guess
 
From the Feedback module manual...

2.1.4. R/C operation
The DiMAX feedback module is ready to
be retrofitted with the wireless DiMAX
feedback transmitter 8133701 (EU
band) or 8132701 (US band). Firmware
V2.0 is required. All the feedback data
is transmitted to the assigned receiver.
The data from the connected slave modules
will be transmitted as well. For the
wireless operation the feedback module
requires an additional power source of
10…24 Volts AC (e.g. track power).
 
Thanks All
The Manual for the Feedback Module 8170001 states for wireless operation the feedback module requires an additional power source of 10-24v ac (track Power) . It dose not state this in the Wireless Feedback manual . It dose state in the Specifications Voltage supply 3.3v (over the feedback module). Just wondering about why the 10-24 v AC it is not stated in this manual. Thanks
 
Another question about the Massoth Feedback Module and the Massoth Feedback Transmitter. Do you have to have the feedback Transmitter fitted to the Feedback module to programme it or can you program the feedback module before you fit the Feedback Transmitter.
 
You should be able to program it before you fit the module as all of the configuration is in the feedback module anyway.
 
You must log in or register to reply here.
Back
Top Bottom