LGB tender and Emotion M install

[Diesel2000]

You say the loco you are trying to pair it with has an MFX decoder. Are you using MFX there or DCC address? Is your tender a different address from the loco? You wont be able to use the same address for both if the loco is using MFX and the tender is DCC. You will need to set them up in the CS3 as a consist and then they should run together with separate addresses.

For the tender problem the CS3 DCC programming leaves a little to be desired. Do you have access to another type CS to try programming the emotion M (like a Massoth 1210z?

 

[Learngartenbahn]

You say the loco you are trying to pair it with has an MFX decoder. Are you using MFX there or DCC address? Is your tender a different address from the loco? You wont be able to use the same address for both if the loco is using MFX and the tender is DCC. You will need to set them up in the CS3 as a consist and then they should run together with separate addresses.

For the tender problem the CS3 DCC programming leaves a little to be desired. Do you have access to another type CS to try programming the emotion M (like a Massoth 1210z?

Thanks for your answer Diesel2000. Sure i know Mfx protocol and Dcc runs both different adress, even if i look like a praticer, i play and collect LGB trains for several years. I already use different locos on the same track without any issues. All my others loco are runing great on track. I have not other material as Marklin CS,3, I've sold my old MTS LGB system 2 years ago. My only solution is to bring my tender to an LGB/Marklin shop i know in Paris. They also have Massoth material perhaps they could programming it...To be continued !