Been adding some tail board marker placement locations to a couple of vans. These are cut from tinplate, cleaned up, edges curved, bottom 3mm bent to right angles, sprayed black then attached in place with Silocone Adhesive. Many suggest this for nameplates etc and logic is stuck on additions that may change/be deleted can be done so with no damage - thus lesson learnt.

Also during this process roof noted loose, this has been glued back in place using a new glue recently discovered by adds on YouTube so hoping that it will work better than the last 2 efforts with Plastic glue then UHU on a less than perfectly bent roof profile. Please do not ask where I got holding clamps, these ha e been in stock nearly 3 decades and only discovered again looking for something else. They are now in my clamps draw.
