John Russo
Registered
Has anyone used JMRI with LGB switch decoders?
I have been adding Turnouts (Switches) to the JMRI Turnout Table.
I can only get to recognize the first switch on each decoder, i.e 1, 5, 9, 13, etc.
Is there a syntax in the Turnout Table to address the other ports, ie. 2, 3,4 6, 7, 8, etc
I have been adding Turnouts (Switches) to the JMRI Turnout Table.
I can only get to recognize the first switch on each decoder, i.e 1, 5, 9, 13, etc.
Is there a syntax in the Turnout Table to address the other ports, ie. 2, 3,4 6, 7, 8, etc