HELP PLEASE!
I have fitted loads of 55021’s and in all cases the lights appeared to work ok except in cases where the Speed Steps were out that can give strange results like flickering lights. On this Loco on Analogue all the Lights were working just fine with 3 at front and 1 at rear correctly showing in each direction. So the Chip has been fitted and nothing. CV Values changed as appropriate as follows:-
29 = 5 (Chip says 28 speed steps not supported on LGB Programming to reverce direction)
49 = 32 Default
50 = 32 Default
51 = 0 us Button 9
52 = 128 Default
53 = 64 Default
Changed to Massoth Hand Held and tried 14/28 and 128 Speed Steps all had no effect on lighting but the Loco still ran ok.
Anything obvious that I have missed please?
I have fitted loads of 55021’s and in all cases the lights appeared to work ok except in cases where the Speed Steps were out that can give strange results like flickering lights. On this Loco on Analogue all the Lights were working just fine with 3 at front and 1 at rear correctly showing in each direction. So the Chip has been fitted and nothing. CV Values changed as appropriate as follows:-
29 = 5 (Chip says 28 speed steps not supported on LGB Programming to reverce direction)
49 = 32 Default
50 = 32 Default
51 = 0 us Button 9
52 = 128 Default
53 = 64 Default
Changed to Massoth Hand Held and tried 14/28 and 128 Speed Steps all had no effect on lighting but the Loco still ran ok.
Anything obvious that I have missed please?