Ralphmp
Registered

I've been advised that if you have a powered layout with a cross-over (e.g. a LGB 13000 or a LGB 12260 double slip) in it that creates a "figure of 8" you don't need a reversing loop module. Is this correct, and if it is why isn't there an issue?
I've drawn this out several times and I always end up with a polarity swap between the different "loops" so what am I not understanding?
Any help in simple terms would help un-addle my tired old brain!
Many thanks
Phil
I've drawn this out several times and I always end up with a polarity swap between the different "loops" so what am I not understanding?
Any help in simple terms would help un-addle my tired old brain!
Many thanks
Phil