
This is a 'heads up'.. followed by an apology to our very own Mark (Muns)!!
Have a Stainz to fit a decoder in..
Number of loco is '2', so set address to '2'..
All is well except the lights don't work. Nada, not a glimmer.. Get a replacement decoder from Mark, and check the programming, change the address to '2', and new decoder does the same!
Set address back to default of 3, and hey-presto! We have lights!!

So,
Brilliant service from Mark as normal.
Need an explanation from Massoth why their firmware is pants! And need to ask the Client what alternate address he would like. - Suppose I cold change the plates on his loco! ???

Have a Stainz to fit a decoder in..
Number of loco is '2', so set address to '2'..
All is well except the lights don't work. Nada, not a glimmer.. Get a replacement decoder from Mark, and check the programming, change the address to '2', and new decoder does the same!
Set address back to default of 3, and hey-presto! We have lights!!


So,
Brilliant service from Mark as normal.
Need an explanation from Massoth why their firmware is pants! And need to ask the Client what alternate address he would like. - Suppose I cold change the plates on his loco! ???



