RhB Tm 2/2 93

The guys in NGRM suggest washing them in white spirit to get rid of the wax, I had trouble with my first FUD model I bought as it was a devil to get it out of corners and bubbles the paint, white spirit and a small paintbrush did the trick though it frosts them white.
 
Washed the 3D printed parts in white spirit with a toothbrush, rinsed in warm water with dishwasher soap and flushed off the soap in running water. Strangely only some areas on the parts got frosted, other parts not so much - but the wax is gone.

20140222_174616.jpg
 
Test drive with Massoth LS decoder and a pair of Massoth automatic uncouplers on a R1 circle. R1 works fine. Both uncouplers are connected to common feeds and the front uncoupler didn`t work most of the time, the rear all the time. I have yet to install the power buffer and hopefully that will solve this issue. If not, I will follow Keiths recommandation seperating the feeds to the uncouplers.

WP_000348.jpg

WP_000350.jpg
 
Now that´s something. It was already spectacular as a build - but to know that it works well is always the final test :o
 
You must log in or register to reply here.
Back
Top Bottom