They look filthy..
Dirty rails and wheels do not work well.
If things are dirty the resistance to current flow will increase, so you will draw less current.
Spiking to 6-8 Amps is more like a short circuit/fault condition.
Break the problem down:
Clean the track.
Clean wheels and pickups.
Start with just one loco, no stock.. - Do you get the problem on one section of track? Is the problem repeatable? Is this crossing a point (turnout)? Reverse loop? Some other 'section detection or switch?
If all are is well, repeat with one consist / set of carriages..
If the fault occurs:
Split the carriages (if possible) see if one half is OK, the other one not. Then break the faulty set down, to isolate where the fault is.
Good luck,
PhilP.