On the LGB one it was possible to run more by doubling (tying two motors together)and increasing the time. I woud think the same is possible with massoth
Quite a few, but as stated already you only have four separately operable connections in the decoder. I have two points connected to several of my Massoth units' connections (i.e. 8 points per switch decoder). No problems at all. I suspect you could go higher as each operation uses about 1 amp of current momentarily, as measured on my layout.
The new point has been doubled up with an existing one and they both perform impeccably.
As the points are virtually "in line" and one forks left and one forks right I should be able to stage manage some heart stopping near misses (provided I press the right paddle!!!!!!!)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.