Massoth Switch Decoder

[electricity_bill]

Hello
I have a Massoth Switch Decoder with four switched outlets. However, S1 and S4 have stopped working whilst S 2 and S3 are Ok. Checked the CVs and can’t spot any errors. The point motor kicks when connected to S1 whilst checking the CVs. Any ideas?
Bill

 

[Gizzy]

What are the addresses for your decoder outputs?

It seems to work if you have a load on S1....

 

[phils2um]

I assume you checked the wiring to the turnouts and turnout motors themselves. You could try a complete reset to ground zero. Check its operation. Then re-program to the switch addresses you want. As I mentioned elsewhere recently, I had to reset a similar decoder multiple times before I finally got it programmed to do what I wanted.

Phil S.

 

[electricity_bill]

What are the addresses for your decoder outputs?

It seems to work if you have a load on S1....

They are addressed as 1,2,3,4 and it just kicks when programming CVs