Old Joe, with the MIK challenge finish I have returned to unfinished projects and being as the least amount of work required was on Old Joe I worked on him. Got the number plate finished along with the whistle, wired up both lights and secured all the screws then tested and it works, fun build, now I have a small industrial steam switch made out of old scrap parts.
He is a combination of parts left from previous builds. Cab is 2 rear sections of Lionel 0-6-0 gold rush special which were left over from my Mason Bogie build, along with the roof and fuel bunker, boiler is PVC fittings, side tanks came from a cut down LGB 2017 that were left from "Rosy's" saddle tanker build, lights came from a LGB 2010 that I built into a Forney, steam dome is a PVC pipe cap, whistle is parts from a electrical connector, left over bell, smoke stack was made from brass 1/4" pipe, firebox is left from my Spreewalt that was the chassis donor for my Mason Bogie build, cab steps were from an old LGB European low side gondola, water fill hatch off a Bachmann 4-6-0 tender from my 2-6-2 prairie build, the chassis and Kadee couplers are new and the bolsters are front is from the rear of the 4-6-0 tender and the rear came from the back on a aristo sloped back tender, Fun build