LGB signals - running against the direction of the signal

N

NigelP

Registered
With an LGB signal rigged under analogue it's easy to run through the signal section in the opposite direction with the signal prototypically showing at red due to the use of a diode (see this diagram http://www.gbdb.info/data/manual/LG...me with the signal showing red? TIA Nigel
 
mine are wired to a suplementry switch unit pluged into a lgb point motor , change a point, signal changes, you could, wire a signal into a switch drive, and change it via a handset
 
NigelP said:
With an LGB signal rigged under analogue it's easy to run through the signal section in the opposite direction with the signal prototypically showing at red due to the use of a diode . . . But under DCC how do you (can you even?) achieve the same with the signal showing red?
Click to expand...
Nigel,
I have not personally used it but I believe the LGB braking module 55063 (or the Massoth equivalent) can be connected to do this, and a lot more if you want. I have not located a current download link for the manual, but its configuration 4. I could email you a copy if you want (PM me with your address).

It depends on how you operate, your budget and your electronic knowledge but its possible to achieve this feature (with varying degrees of realism) from full computer control to relatively simple relay logic.

Hope this helps

Don
 
The "Multi function + breaking" module is still available from Massoth, I do not list the on my web site and my standard retail price for one would be £84.

Note you will need a MTS Power booster as well.
 
You must log in or register to reply here.
Back
Top Bottom