I have two locos with supposedly identical controls (19.8v battery, Deltang Rx102, GScale Graphics Enhanced Railboss, Phoenix P8). Both run beautifully.
But one drives me potty because it can't stop ringing its bell from start up to shutdown every few seconds - without any manual triggers!
The only way to stop it is to disconnect the bell trigger wire ESC to P8 OR turn the bell down to 0% volume but I don't want to lose 50% of my premium sound triggers.
This is what I have done so far:
Tried tweaking all the Phoenix Bell parameters
Changed from one triggered sound (bell) to another (water fill) - exactly same problem with water fill
Reloaded software from original Phoenix ROM files
Reset everything to factory default settings
Treble checked wiring Rx-ESC-P8 is identical to its twin
Any other suggestions please?
mike in Despair
But one drives me potty because it can't stop ringing its bell from start up to shutdown every few seconds - without any manual triggers!
The only way to stop it is to disconnect the bell trigger wire ESC to P8 OR turn the bell down to 0% volume but I don't want to lose 50% of my premium sound triggers.
This is what I have done so far:
Tried tweaking all the Phoenix Bell parameters
Changed from one triggered sound (bell) to another (water fill) - exactly same problem with water fill
Reloaded software from original Phoenix ROM files
Reset everything to factory default settings
Treble checked wiring Rx-ESC-P8 is identical to its twin
Any other suggestions please?
mike in Despair