electricity_bill
Registered
Hello again
I have just finished fitting my "new" old stock Aristo GP40 with an MRC 1817 sound decoder. I have used this decoder a few times before with great success but I have a snag this time. The loco runs fine if a little slow and the sound works. However, all the function buttons 1-16 all just produce the bell sound i.e. no horn,air brakes etc. I have looked through the CVs but cannot find anything that would account for this. I am running the Massoth Navigator system.
Any ideas?
Bill
Just searched on MRC in the forum and found the answer. It was a series/ parallel problem which I have now overcome. Thanks guys.
Bill
I have just finished fitting my "new" old stock Aristo GP40 with an MRC 1817 sound decoder. I have used this decoder a few times before with great success but I have a snag this time. The loco runs fine if a little slow and the sound works. However, all the function buttons 1-16 all just produce the bell sound i.e. no horn,air brakes etc. I have looked through the CVs but cannot find anything that would account for this. I am running the Massoth Navigator system.
Any ideas?
Bill
Just searched on MRC in the forum and found the answer. It was a series/ parallel problem which I have now overcome. Thanks guys.
Bill