- 14 Jun 2011
- 4,063
- 947
- Best answers
- 0
Because my new printer is not listed in Creality Slicer, the one that comes with it, I decided to use Cura as my slicer for it.
Being a total novice with Cura I searched the net looking for tutorials and found this.
It explains the various settings clearly and I thought it may be of some use to others.
Being a total novice with Cura I searched the net looking for tutorials and found this.
It explains the various settings clearly and I thought it may be of some use to others.
Cura Settings Ultimate Guide - Settings Explained & How to Use
Cura has plenty of settings that contribute to creating some great 3D prints with filament 3D printers, but a lot of them can be confusing. There are pretty good explanations on Cura, but I thought I’d put together this article to explain how you can use these settings. So, let’s look at some of...
3dprinterly.com
- 3
- Show all