I would swap the Rx for a RCT-MR001a (manual, or auto bind).. And couple this with a RCT-ESC260 speed controller.
MR001a will get power from the BEC on the ESC, and use Channel/Pin 1 for control of the ESC.
All other pins can be programmed to give (up to) six additional sound triggers.
ESC260 is good to 28V and a load of 100W, and has dedicated directional lighting outputs.
In round-figures, £60.00 programmed to your requirements, and delivered.
PhilP.
Looks like a good dealI would swap the Rx for a RCT-MR001a (manual, or auto bind).. And couple this with a RCT-ESC260 speed controller.
MR001a will get power from the BEC on the ESC, and use Channel/Pin 1 for control of the ESC.
All other pins can be programmed to give (up to) six additional sound triggers.
ESC260 is good to 28V and a load of 100W, and has dedicated directional lighting outputs.
In round-figures, £60.00 programmed to your requirements, and delivered.
PhilP.
We have the tech-no-logy...Thanks Phil, sounds very interesting.
Sorry I omitted Low-Off? from my list of MustHaves
Mike
Thank you Phil for all your patient and speedy help on this one, very much appreciated - again!
Our No. 1 Man