That looks nice, what is it?

[tramcar trev]

That looks nice? But what is it??
Its called in tramway circles a GCG, groove cutting guide/gizmo/gadget? when its seen screwed to the base of a Dremel router its use becomes obvious, doesn?t it? In use it?s guided along the inside edge of the rail on the 2 brass pins and the carbide cutter cuts away the material forming the groove for the wheel flange to run in. Being a carbide cutter it will be used to form the groove when the space between and around the rails is macadamised or paved or whatever granite setts always look nice?

 

[trammayo]

Nice milling tool Trev

 

[Andrew]

That is a pretty nifty idea! My mind is ticking over again with ideas.
Andrew
Sandbar & Mudcrab Railway

 

[mike]

dam clever!

 

[MR SPOCK]

save a lot of filing and fidgeting about​

 

[Richie]

What a great idea nice work Trev

 

[tramcar trev]

You people are toooooo kind.... Then again some of you could rip this idea off and make a fortune from it .....
Wait till you see how Im going to make the granite setts to pave my roads with so that I can cut the grooves in them..... Same technique as is used to make stamped concrete. Thats a big business in Australia... Im just going to minaturise it to suit my purposes....
I confess I did try the Dremel grout remover and its no good in this application