A while back there was a thread about bending flexi-track
http://www.gscalecentral.net/m146423
to which I contributed. One of the responses was from Bobg who described a little device he had made, called a jim-crow. I was so intrigued I asked him to make one for me - for a modest price.
It's very easy to use. Slot it over the rail, twist the handle a couple or three turns and Bob's your uncle (sorry Bob - pun accidental(ish)!!)
I've been spending a happy time going round the railway tweaking some of my more 'angular' rail joints.
Bob says he's prepared to make a few more if anyone else is interested - and I said, as a satisfied customer, that I would mention it on the forum. I'm sure if you drop him a PM he'd advise.
Hope that's OK Bob - and thanks again for sorting out some of my more more visible kinks!
Rik
http://www.gscalecentral.net/m146423
to which I contributed. One of the responses was from Bobg who described a little device he had made, called a jim-crow. I was so intrigued I asked him to make one for me - for a modest price.
It's very easy to use. Slot it over the rail, twist the handle a couple or three turns and Bob's your uncle (sorry Bob - pun accidental(ish)!!)
I've been spending a happy time going round the railway tweaking some of my more 'angular' rail joints.
Bob says he's prepared to make a few more if anyone else is interested - and I said, as a satisfied customer, that I would mention it on the forum. I'm sure if you drop him a PM he'd advise.
Hope that's OK Bob - and thanks again for sorting out some of my more more visible kinks!
Rik