Deltang RC setup not connecting

R

Robert Howard

Registered
Hi All,

Been a while since I have been on this site but would really appreciate any help.

I am using Deltang RC with battery power on all my locos which has been great for two years but recently two receivers have started playing up. A RX 102-1 and a newer RX 65.

I can bind them OK to transmitters and control the loco. But, if I turn everything off and on again, the transmitter and receiver do not connect. Constant light on transmitter and slow flash on receiver.

I can successfully use my TX-22 controller with other receivers on other locos, so I think the problem is the receiver but could be wrong.

All of my kit has been well used by my kids and dropped etc so breakages are possible.

Any ideas?
 
It does sound like a Receiver problem..

A reset of the receivers *might* help, but it may require them going back to have the software reloaded.
 
Do a Google-search for 'Deltang paper clip settings'..

That will not only tell you how to do the reset, but will also allow you to confirm that 'Selecta' is enabled on the receivers.
 
As Phil says. Check the Selecta settings on each rx first. The 'factory reset' function is not always successful so only use that as a last resort. Failing that, it's a case of return to supplier to have the software reinstalled.

Rik
 
You must log in or register to reply here.
Back
Top Bottom