Hi Everybody
I want to control a servo to rotate 180 degrees, I've bought a Tower Pro MG995 & check it does turn 180 (by just connecting with power leads). I want to control the rotation using my Spektrum DX6i via a Spektrum AR610c receiver but using this I can only get a standard turn of 60 degrees. My knowledge of electronic is almost zero so any advise would be most welcome. My thought is to put in a "speed controller " to amplify the signal to the servo & there by increase the amount of turn, would this work ?
Thanks for your time
I want to control a servo to rotate 180 degrees, I've bought a Tower Pro MG995 & check it does turn 180 (by just connecting with power leads). I want to control the rotation using my Spektrum DX6i via a Spektrum AR610c receiver but using this I can only get a standard turn of 60 degrees. My knowledge of electronic is almost zero so any advise would be most welcome. My thought is to put in a "speed controller " to amplify the signal to the servo & there by increase the amount of turn, would this work ?
Thanks for your time
