Buhler Motors (LGB 62201 I think)

Buy now for 25.00 GBP - Expired
  • Thread starter Thread starter kenefd
  • Start date Start date
  • Quantity Qty: 5
I have 5 probably new Buhler motors for LGB older locos. All tested and working fine. Stored for a while now and just rediscovered. Short shaft, 2.4 mm dia and 15 mm long. I am happy to sell posted for £25 each.
KenDSCN5488.JPGDSCN5488.JPGDSCN5487.JPG
 
Last edited:
Shouldn't that motor in the picture have a shaft sticking out of it, Ken, preferably with a worm on it....?

Jon.
 
It is not a 'short-shaft' motor, for sure..

I think they may be for the older (definitely pre-Marklin) LGB rack loco's?

Which would make them 62205's ?? :nerd::think::think:
 
Thanks Ken. Are the motor casings the same diameter and length as a "standard" LGB motor?
They must be for a specific model, possibly the rack loco as PhilP suggests - certainly not suitable as replacement motors for standard LGB gearboxes.

With the dimensions known, they might be of interest to someone building a loco chassis from scratch....

Jon.
 
Zerogee said:
Thanks Ken. Are the motor casings the same diameter and length as a "standard" LGB motor?
They must be for a specific model, possibly the rack loco as PhilP suggests - certainly not suitable as replacement motors for standard LGB gearboxes.

With the dimensions known, they might be of interest to someone building a loco chassis from scratch....

Jon.
Click to expand...
That's still fairly pricey - I know it's Buhler, but .............................. :nerd::nerd::nerd:
 
Thanks everyone. I recall having to change the brushes on a old 2-6-2 and thought this was the same, I will see if I still have any specifications.
 
As people are unsure of its type and following Rhinochugger's advice I am prepared to take offers for these motors.
 
kenefd said:
As people are unsure of its type and following Rhinochugger's advice I am prepared to take offers for these motors.
Click to expand...
Can you humour me, and measure the spacing of the screw holes on the end please :nerd::nerd:
 
Centre to centre of the holes in the end is 16 mm, body length without shaft 54.5 mm. Diameter of body 30 mm. Hope this helps, if you want one or more try an offer.
 
kenefd said:
Centre to centre of the holes in the end is 16 mm, body length without shaft 54.5 mm. Diameter of body 30 mm. Hope this helps, if you want one or more try an offer.
Click to expand...
I have started a conversation - there'll be a little number on the top menu bar to the right of your avatar :nod::nod:
 
You must log in or register to reply here.
Back
Top Bottom