Big Hauler Remote

[Greg Elmassian]

Standard names are hard to come by, you should measure the pin pitch, and then find the connector.

I could point you to the right places in the USA, but not the UK.

I think you will find that the 4 pin connector will pop out to allow closer inspection.

Of course you can just cut the connector off, solder the 4 wires into 2 and put a connector on the 2 wires.

Greg

 

[stockers]

It is the usual LGB block. I pretty sure I have one redundant if you need it.

 

[mcr22]

Thanks guys..........Stockers: if you have a spare I would be very grateful.
George

 

[stockers]

I will go look.

 

[stockers]

Found one. attached to the backhead switch fitted to most LGB locos. You can chop that off and still have about 6 inches of wire to use or attach to. Send me a 'conversation' (the funny envelope symbol, top right of page) with your address and I'll get it out to you on Monday.