ALL SOLD... Train Engineer RC TX handset and 3 x DC RX Receiver base stations with fans and 13 amp power supply 13.8,18,23 volt

SOLD
Aristocraft/Crest Train Engineer system
The items can be bought separately but I would obviously prefer them to go as a whole unit.
1 X ART/CRE 55465 Elite power supply with three available voltage offering 13 amps of power
3 X ART/CRE 55470 RX receiver (10 amp handling) Linear and PWC DC
1 X ART/CRE 55473 TX transmitter handset

Fully tested

PRICES
ART 55471 10 amp receiver £50 each plus P&P (there are three)
ART 55473 transmitter handset £70 plus P&P
Crest 'Elite' 13 amp power supply £99 plus P&P

I also have some point and accessory receivers on offer the ones in the photos here are not included in this sale but are in my other 'For Sale' posting

 

[beavercreek]

My 'real' Train Engineer set up is now for sale....... I have changed the first post of the thread to reflect this but also reproduce it here.

For sale
Aristocraft/Crest Train Engineer system
The items can be bought separately but I would obviously prefer them to go as a whole unit.
1 X ART/CRE 55465 Elite power supply with three available voltage offering 13 amps of power
3 X ART/CRE 55470 RX receiver (10 amp handling) Linear and PWC DC
1 X ART/CRE 55473 TX transmitter handset

Fully tested

PRICES
ART 55471 10 amp receiver £50 each plus P&P (there are three)
ART 55473 transmitter handset £70 plus P&P
Crest 'Elite' 13 amp power supply £99 plus P&P

I also have some point and accessory receivers on offer the ones in the photos here are not included in this sale but are in my other 'For Sale' posting

 

[beavercreek]

EVERYTHING SOLD

 

[JimmyB]

Just for interest here is my point control board with two cre55475s and a number of latching relays. Yes there are a lot of wires but this controls 13 points (some paired), 2 isolated sections and a light indicator system to show which way the points are set on the outside of the shed.

Chris, what are the ratings for the relays, I assume the latched "output" come from the TE, and the cabling is appropriate. also what do you power your 55475s from.

 

[beavercreek]

Hi Jimmy I have sent you a couple of PMs covering the power supply for the 55475 and 55474 receivers
The 55475 (5 point output) uses momentary pulse for the point motors so the motors don't get burnt out.
The 55474 (besides the point outputs) does also have 2 accessory outputs but if you are using any high drain stuff you will need relays and Chris can tell you all you will need to know as that is what he has set up.

 

[JimmyB]

There are a number of links to document on "gscale.net" unfortunately I don't seem to be able to get any to work!

 

[beavercreek]

There are a number of links to document on "gscale.net" unfortunately I don't seem to be able to get any to work!

Yeah, the links were working on Tuesday but the whole gscale.net site seems to have gone!