New people files uploaded

[3 minutes of fame]

Evening All.
I've upload a dozen new people STLs to the resources section. Feel free to download and print. There's some Edwardian figures, as well as some more modern people, mostly scanned by me.

I've also added a paid for print service for anyone without access to a resin printer. The cost includes 5% commission, so you will be supporting the forum as well.

 

[trammayo]

Went to Resources but couldn't view any figures!

 

[3 minutes of fame]

Went to Resources but couldn't view any figures!

Was there not a button at the top of the page saying Go to download? That should take you to a Google drive page with the files available for download.

 

[idlemarvel]

Was there not a button at the top of the page saying Go to download? That should take you to a Google drive page with the files available for download.

I think you mean DropBox page not Google Drive.

 

[3 minutes of fame]

I think you mean DropBox page not Google Drive.

It should be a drive folder. I've set it up for sharing.

Shared People – Google Drive

 

[3 minutes of fame]

 

[3 minutes of fame]

I've added images to the library, so you can see each print. More photos of printed samples below:

 

[Technocrat]

THANKS!

Annie is printing as I type.

 

[3 minutes of fame]

THANKS!

Annie is printing as I type.

Excellent. Would love to see the end result!

 

[IanMTrain]

Thanks for the STLs of figures - I have been looking for some railway figures to print. These look very hopeful, although I do not have a resin printer. Still from 6ft I suspect they will look fine with a dash of paint.

 

[3 minutes of fame]

Thanks for the STLs of figures - I have been looking for some railway figures to print. These look very hopeful, although I do not have a resin printer. Still from 6ft I suspect they will look fine with a dash of paint.

I'll happily print any of them for you. £12 each, including postage. Discount if more than 2 are ordered at the same time to £8 each.

 

[IanMTrain]

Thanks for the offer - I am currently getting my head round controlling my Dreamer printer and working out what works and what doesn't. Currently learning not to skimp on the supports - it may save time but certainly doesn't save filament when the print fails.

If I don't get a reasonable finish I'll certainly be back for some resin prints.

 

[3 minutes of fame]

Thanks for the offer - I am currently getting my head round controlling my Dreamer printer and working out what works and what doesn't. Currently learning not to skimp on the supports - it may save time but certainly doesn't save filament when the print fails.

If I don't get a reasonable finish I'll certainly be back for some resin prints.

No worries.
Best advice I can give you is to print the people standing up, not laying down, as the limited resolution won't be so noticeable. Plenty of supports on arms and hands, but otherwise these should print OK. Print at 0.12mm for maximum detail, even if it takes a little longer than the standard setting.

 

[3 minutes of fame]

Now added to the model directory - some ground signals. These are modified from a Thingiverse design, to print in 2 pieces in resin, and to be single head rather than dual head. Original file here: G Scale Signal Light by ShadowVFX

 

[3 minutes of fame]

I've found a very nice set of files here: EMAIL_SUBSCRIBERS I am not copying them into my files, as they are not my designs. Some nice modern people though!