Multiple Massoth Feedback Modules

Ralphmp

Ralphmp

Registered
Country flag
I currently have a single Massoth Feedback Module connected wirelessly to my central station. I'd like to add a second module and, whilst the manual shows it is possible to daisy chain multiple modules together using a cable, I can't see anything about using multiple modules that connect wirelessly. Just wondered if anyone has done this and, if so, are there any pitfalls to avoid.

Thanks in advance.
 
If the feedback modules are local to each other, connect them with a cable, ensure that the they are connected "slave" to "slave" and that the first is the module with the feedback transmitter.

If they are far apart, you will need to add a feedback transmitter to the second module.

Ensure that all modules directly connected to the DiMAX bus (i.e not chained together via the slave ports) and those that are connected wirelessly have unique BUS IDs.
 
RC Band CV 100 = 0
RC Channel CV101 = (1 to 4) this should match the existing setup, check from Navigator RC menu.

Check what the other devices are in use and what their ID's are, and set the additional wireless feedback module to an unused number.

RC ID CV 102 = 1 to 8

(From my own use, Navigators are set to the lower numbers, additional wireless devices start at 8 and work down)

Remember to change the Contact Numbers, use the next consecutive block of 4, for CV 51, CV 61, CV 71 and CV 81

Contact Number CV1 = 0
ID Number CV2 to 12? assuming the first Feedback units ID Number is 11
Bus Type CV 3 = 1

Other than all the aerials are kept clear of obstructions, nothing really to add.
All the wireless devices, Navigators, Receivers and wireless Feedback Modules including a mixture of allsorts of Massoth, PIKO and LGB equipment have worked together with no problems experienced to date.
 
Ah, Ralphpmp, you will be needing my feedback module and wireless transmitter I advertised for sale a while ago ! ?
 
You must log in or register to reply here.
Back
Top Bottom