LGB 22460 Rack Loco & 5 Volt Lighting

S

Sammler

Registered
I'm planning on fitting a decoder into a LGB 22460 Rack loco that requires an LGB 55021 decoder and an LGB 55026 interface cable.

Question is, do I need to change any CV values for the 5 volt lighting or will the original analogue board reduce the decoders voltage automatically? I've tried searching for some instructions for this loco but all I can find are diagrams.

Thanks
 
No, the voltage regulation for the lights is taken care of by the original board.
You just need to change-over the DIP switches when you fit the decoder.
 
You must log in or register to reply here.
Back
Top Bottom